Categories
- MADE BY E-R.IO IN EUROPE
- CRODUINO
- INKPLATE
- easyC
- RASPBERRY PI / BBC MICRO:BIT
- 3D PRINTING
- BREADBOARDS & CABLES
- POWER SOURCES & BATTERIES
- SENSORS
- ACTUATORS
- COMMUNICATION
- TOOLS & LAB EQUIPMENT
- SOLDERING KITS
- COMPONENTS
- CLEARANCE
- Home /
- CAN breakout
Description
Controller Area Network (CAN) is a network technology that enables fast communication between microcontrollers, and is the most commonly used standard in cars. Our CAN breakout uses an MCP2518FD CAN whose communication between microcontrollers takes place on SPI protocol. In addition there is a CAN transceiver. This breakout allows use of both standards (CAN 2.0B and CAN Flexible Data (FD)). Access to the CAN bus is possible via CANH and CANL pins on the screw terminal. The 120ohm terminator resistor is also located on the board and can be connected to a jumper.
• Standards: CAN 2.0B i CAN FD
• Voltage: 2.7V i 5V
• Current: from 10uA to 12mA
• SPI interface
• Dimensions: 34 x 24.5 x 13mm
Tier Pricing
0
Out of stock
SHIPPING & RETURNS
We ship internationally via Croatian Post or GLS express service for Europe. GLS express will deliver your package within few workdays(depends on location) and provide you tracking number. Croatian Post shipping is without tracking and might take up to 14 workdays to deliver for Europe and up to 30 workdays to deliver for rest of the world(but usually delivers under 3 weeks).
Returns are accepted in 14 workdays after purchase as long as the product is in original undamaged packaging.
- Description
-
Details
Controller Area Network (CAN) is a network technology that enables fast communication between microcontrollers, and is the most commonly used standard in cars. Our CAN breakout uses an MCP2518FD CAN whose communication between microcontrollers takes place on SPI protocol. In addition there is a CAN transceiver. This breakout allows use of both standards (CAN 2.0B and CAN Flexible Data (FD)). Access to the CAN bus is possible via CANH and CANL pins on the screw terminal. The 120ohm terminator resistor is also located on the board and can be connected to a jumper.
• Standards: CAN 2.0B i CAN FD
• Voltage: 2.7V i 5V
• Current: from 10uA to 12mA
• SPI interface
• Dimensions: 34 x 24.5 x 13mm - Additional Information
-
Additional Information
quantity for 1 pc Project1 Datasheet project-link1 https://e-radionica.com/productdata/MCP2518FD-CAN.pdf Project2 No project-link2 No Project3 No project-link3 No Tutorial1 No tutorial_link1 No Tutorial2 No tutorial_link2 No Tutorial3 No tutorial_link3 No
Comment and Review